Buoyancy Effect of Bristles for a Brush Seal with Disturbance-Suppressing Holes

2024-11-1

Numerical Investigation of Stall Characteristics and Stall Control of Circulation Control Airfoil

2024-11-1

Refined Bird Model Considering Soft and Skeletal Tissues for Bird Impact Simulation

2024-11-1

Experimental Structural Design of a Novel Variable-Sweep Wing Based on a Four-Bar Planar Linkage

2024-11-1

Modeling and Contribution Analysis of Vibration Transfer Paths for a Dual-Rotor Aeroengine

2024-11-1

Experimental Exploration of Bioinspired Planar Wingtip Devices for a Flat-Plate Wing in the Low Reynolds Number Regime

2024-11-1

Aircraft Closed-Loop Dynamic System Identification in the Entire Flight Envelope Range Based on Deep Learning

2024-11-1

Transonic Buffet in Flow Past a Low-Reynolds-Number Airfoil

2024-11-1

Investigating Interlaminar Stresses in Stress Concentration Zones of Laminated Composite Shells of Revolution Using Quasi-3D Theory with the Transverse Stress Recovery

2024-11-1

Orbit Design and Optimization for Point Target Revisit in LEO-LEO Occultation

2024-11-1

Optimized Generative Topographic Mapping Method for Aerodynamic Design Optimization

2024-11-1

A Compressor Stall Warning System for Aeroengines Based on the Continuous Wavelet Transform and a Vision Transformer

2024-11-1

Experimental Study of the Periodic Vortex Shedding and Lock-in Region of an NACA4412 Airfoil

2024-11-1

Numerical Simulation of the Aerodynamics of a Scaled Free Jet Altitude Test Facility Model

2024-11-1

Saturation-Optimized Quasi-Sliding-Mode Calming Control of Free-Flying Space Robots Based on Model-Free Adaptive Control Theory

2024-11-1

Machine Learning–Aided Synthetic Air Data System for Commercial Aircraft

2024-11-1

Lunar Leap Robot: 3M Architecture–Enhanced Deep Reinforcement Learning Method for Quadruped Robot Jumping in Low-Gravity Environment

2024-11-1

Single-Point and Multipoint Design of Propellers for Electric-Powered General Aviation

2024-11-1

Optimal Scheduling of K-M-N GEO On-Orbit Service Network Based on Hybrid Simulated Annealing Algorithm

2024-11-1

Trajectory Tracking Control Based on Generalized Rodrigues Parameter for Underactuated VTOL UAVs

2024-9-13

Adaptive Fuzzy Sliding Mode Controller Design Using a High-Gain Observer for a Nonlinear Aeroelastic System under Unsteady Aerodynamics

2024-9-13

Novel Active–Passive Piezoelectric Hybrid Constrained-Layer Damping Technique for Vibration Isolation in a Whole Spacecraft

2024-9-12

Airfoil Aerodynamic Optimization Design Using Ensemble Learning Surrogate Model

2024-9-10

Topology Optimization of 3D Turbine Disk Considering Thermal Load Based on BESO Method

2024-9-1

Dynamic Stall Alleviation of a Helicopter Blade Section in Forward Flight Condition Using an Optimized Combination of Active Nose Droop and Active Gurney Flap

2024-9-1

Robust Optimization of the Secondary Air System Axial Bearing Loads with the Labyrinth Clearance Uncertainty

2024-9-1

Determining Peak Shock Pressure and Cratering due to Hypervelocity Meteoroid Impact on Lunar Structures for Engineering Design

2024-9-1

Motion Analysis of Bending Bar Tensegrity Robot

2024-9-1

Obstacle-Avoidance Safety-Guaranteed Rendezvous Control with a Velocity Safety Corridor and Prescribed Performance

2024-9-1

Ground Effects on the Aerodynamic Performance of Microducted Fan Systems

2024-9-1

State-Space Perturbation Analytical Solution for the Dynamics of Launch-Vehicle Boost Phase

2024-9-1

Development of a Mathematical Model of a Coaxial Compound Helicopter for Trimming and Stability Analysis

2024-9-1

An Evaluation of Torque Characteristics of a Spherical Magnetohydrodynamic Attitude Control Device

2024-9-1

Optimal Transition of Coaxial Compound Helicopter after Total Propeller Failure

2024-8-24

Numerical Study of Flow and Noise Control Mechanism of Shape-Optimized Series Cylinder

2024-8-13

High Computationally Efficient Predictive Entry Guidance with Multiple No-Fly Zones

2024-8-13

TD3-Based Model Predictive Control for Satellite Formation-Keeping

2024-8-5

Numerical Investigation of the Effect of the Cavity on Flow Control of Continuous Pulses Opposing Plasma Synthetic Jets in Hypersonic Flow

2024-7-13

Designing a Stiffener Layout that Resists the Wrinkling Behaviors of Sandwich Panels

2024-7-13

<i>Anelosimus eximius</i> Colony Algorithm and Its Application to Celestial Doppler Difference Velocimetry

2024-7-13

Biaxial Buckling Analysis of Soft-Core Functionally Graded Graphene-Reinforced Sandwich Plates

2024-7-13

Aerodynamic Flutter Analysis Based on Experimental and Hybrid Modal Parameters

2024-7-12

Autonomous Navigation for Cellular-Connected UAV in Highly Dynamic Environments: A Deep Reinforcement Learning Approach

2024-7-11

Camber Effects on the Leading-Edge Suction, Forces, and Vortex Dynamics of Unsteady Airfoils

2024-7-11

Aerodynamic Parameter Estimation for Near-Stall Maneuver Using Neural Networks and Artificial Bee Colony Algorithm

2024-7-10

Neural Network Reentry Guidance for Reusable Launch Vehicle Based on Sample Dimensionality Reduction

2024-7-10

Quadrilateral Pose Estimation for Constrained Spacecraft Guidance and Control Using Deep Learning–Based Keypoint Filtering

2024-7-10

Neural Network–Assisted Initial Orbit Determination Method for Libration Point Orbits

2024-7-1

Aerodynamic and Aeroacoustic Optimization of UAV Rotor Based on Proper Orthogonal Decomposition Method

2024-7-1

Research on Oscillation Response of Pressure-Combustion-Thrust System in Solid Rocket Motor

2024-7-1