Research on Virtual Prototype and Digital Test Method of Pump-Fed Propulsion System

2024-9-14

Monocular SLAM with Point and Line Features Applied to Spacecraft Relative Navigation

2024-9-11

Real-time Path Re-planning to Deal with Dynamic Obstacles Using a Parallel Probabilistic Roadmap

2024-9-11

Event-Triggered Adaptive Fixed-Time Trajectory Tracking Control for Stratospheric Airship

2024-9-10

Experimental and Numerical Investigation on Attitude Adjustment Characteristics of Spacecraft with Impulse Thruster

2024-9-9

Learning and Fast Adaptation for Air Combat Decision with Improved Deep Meta-reinforcement Learning

2024-9-9

Performance, Vibration, Load, and Whirl Flutter Stability Analyses of Tiltrotors with Swept-Back Blades

2024-9-5

UAV Autopilot Design for Entire Flight Profile with Cubature Kalman Filter

2024-9-3

Fragment Identification Method Based on DBSCAN and Its Application in Hypervelocity Impact of Whipple Shield

2024-9-1

An Assessment of Explosive and Fire Risks from Fighter Jet Collision with Aircraft Carrier

2024-8-31

CubeSat Antenna Designs in the Last 2 Decades (2002–2023): A Survey

2024-8-28

Soft Landing of a Hybrid Rocket Thruster Powered Platform: Hardware-in-the-Loop Simulation

2024-8-24

Development of a Lunar Vehicle with a Hybrid Rocket Engine Produced Using Lunar Resources

2024-8-24

Optimal Vertiport Locations for Air Taxi Services in Seoul Metropolitan Area

2024-8-24

Analysis of Interaction Between Two V Tails Based on Dynamic Mode Decomposition

2024-8-24

Multidisciplinary Design Optimization Processes for Efficiency Improvement of Aircraft: State-of-the-Art Review

2024-8-23

Supersonic MLN Thrust Correction at HT with Application to The Missile Trajectory

2024-8-15

Optimizing Nanosatellite Power Generation Integrating Heat Pipes and Thermoelectric Generators for Low Earth Orbit Conditions

2024-8-12

A Design Approach for Piccolo Tube Fuel Diffusers to Meet Airworthiness Requirements

2024-8-8

Study on Characteristic Modeling and Command Tracking Control Method for Variable Configuration Aircraft

2024-8-7

Tracking of Maneuvering Extended Object with Random Hypersurface Model Based on Adaptive Uncorrelated Conversion Filter

2024-8-5

Investigation of the Characteristic Length Scale and Influencing Factors for Supersonic Gas Jets

2024-8-5

Active Vibration Suppression of the Wind Tunnel Model Support Structure by Positive Position Feedback Controller with Robust Phase Compensator

2024-8-2

Flight Test Design and Nonlinear Model Identification for Landing Gear Aerodynamics

2024-7-27

Improved Design of Beach Ball Constellation for Constant Revisit Time in LEO Reconnaissance

2024-7-27

Comparative Analysis of Inerting Effects of Open and Closed Vent Systems Fuel Tanks

2024-7-26

Relative Navigation Performance of LEO Vehicles Considering GPS–KPS Constellation and Measurement Characteristics

2024-7-26

Optimization of RAIM Based on Dual-Frequency Dual-Constellation INS Integrated Navigation System

2024-7-25

Thermal–Structural Coupled Analysis and Design of a Reentry Capsule with Ablative Thermal Protection Systems

2024-7-23

Genetic Algorithm-Based Approach for Improving Temporal Resolution in Constellation Operation of National Satellites

2024-7-23

An Investigation on V-Notch Controlled Asymmetric Supersonic Jet

2024-7-22

Enhancing Human Comfort in eVTOL Aircraft Assisted by Control Moment Gyroscopes

2024-7-19

A Numerical Investigation of Particle Swarm Optimization to Improve Film-Cooling Effectiveness from Converging Slot Hole

2024-7-17

Investigation of a Variable Camber Morphing Airfoil via SMA Wire and Corrugated Structures

2024-7-12

Real-Time Path Planning for Unmanned Aerial Vehicles Based on Compensated Voronoi Diagram

2024-7-11

Performance Analysis of a Ducted Rocket Under Various Flight Conditions

2024-7-10

A Novel Engine Fault-Tolerant Control Method Based on Input Scheduling for Tiltrotor Aircraft

2024-7-10

Investigation of the Laminating Characteristics of CFRP Plates with a Thin and Wide Configuration in Production for an Effective Inspection Process

2024-7-10

Neural Adaptive Sliding Mode Control for Camera Positioner Quadrotor UAV

2024-7-10

Study on the Effects of Aft Deck Geometry on Plume Shield Ratio

2024-7-9

Dynamic Takeoff and Landing Control for Multi-Rotor eVTOL Aircraft

2024-7-9

Crashworthiness of Energy Absorbing Structures Under Combined Shear-Compression Loading: Effects of Materials and Geometries

2024-7-6

Thermal Analysis and Control Design for Space Optical Telescope ROKITS

2024-7-5

Tube-Based Composite Fault-Tolerant Control Method for Flexible Hypersonic Vehicle

2024-7-4

Impact of Additive Manufacturing Surface Roughness on the Aerodynamic Performance of Axial Compressor Blades

2024-7-4

Incorporating Airspace Constraints in Multi-phase 4D Trajectory Optimization Based on Improved Adaptive Mesh Refinement Method

2024-6-26

A Comprehensive Survey on Multiple-Runway Aircraft Landing Optimization Problem

2024-6-25

Prediction of Airfoil Lift Coefficient Based on Multilayer Perceptron

2024-6-24

Numerical Study on the Dynamic Behavior of Layered Structures under High-Velocity Impact

2024-6-19

Multi-stage Johnson–Cook Model for Collision Analysis: Impact Experiments and Simulations

2024-6-19