Bone machining: an analysis of machining parameters such as cutting speed, feed rate, and depth of cut using bovine bone

2020-1-1

Linear and nonlinear stability analysis of hydrodynamic journal bearings using mass-conservative cavitation model

2019-9-1

Effects of flow factors variabilities on lubrication characteristics of mechanical seals

2019-9-1

Thermal stress analysis of the multi-disc friction clutches

2019-5-1

Fundamental study on functionality of synthetic sulfides : Evaluation of metal sulfides as solid lubricant

2019-3-1

Macroscopic tribological properties of thick concentrated polymer brush on rough steel under lubrication with ionic liquid

2019-3-1

Parametric investigations of short length hydro-dynamically lubricated conical journal bearing

2018-12-1

Effects of velocity-slip and viscosity variation in hydrostatic step-seal

2017-1-1

Influence of calcination temperatures on structure and magnetic properties of calcium ferrite nanoparticles synthesized via sol-gel method

2017-1-1

Effects of dispersed sulfides in bronze under line contact conditions

2016-3-27

Optimization of wear behavior of electroless Ni-P-W coating under dry and lubricated conditions using genetic algorithm (GA)

2016-1-1

Effect of CVD-diamond coatings on the tribological performance of cemented tungsten carbide substrates

2016-1-1

Comparative physico-chemical analysis of low-price bulk Nigerian commercial engine oils

2016-1-1

Friction and wear of bearing material under water contaminated compressor oi

2015-1-1

Potential of palm kernel activated carbon epoxy (PKAC-E) composite as solid lubricant: Effect of load on friction and wear properties

2014-9-20

Lubricity of bio-based lubricant derived from chemically modified jatropha methyl ester

2014-6-1

Comprehensive bearing condition monitoring algorithm for incipient fault detection using acoustic emission

2014-1-1

Evaluation on the tribological properties of palm olein in different loads applied using pin-on-disk tribotester

2014-1-1